Inspection

Inspection Details

Equipment ID
1727

Inspection Date
12/13/2022

Inspection Type
Annual Inspection

Inspector Name
Michial Linenfelser

Mechanic Name
Jake Brennan

Relief Valve Pressure

Slide
Na

Governor Rope Pull
Na

Door Closing Force
24

External ID
3529d26f-c2e8-483d-9407-fb6a7b948b7e

Location

Mercy Hospital Washington
901 E 5th St, Washington, MO
Phone: (636) 239-8671
Email: barry.smith@mercy.net

Owner

Attn: Tara
Mercy Hospital East Communities
901 E 5th St, Washington, MO 63090
Phone: (636) 239-8086
Email: Tara.Carey@mercy.net

Billing

Same as Owner

Violations

Code	Item	Section	Reinspection	Reason For Violation	Fixed Date
conversion	conversion	n/a		A grease seal on the drive machine is leaking excessively and shall be replaced.	7/10/2020
conversion	conversion	n/a		The machine room lighting has been changed to a motion type switch to activate. While this is an energy saving measure, it also is a safety/code concern. Without motion, the switch deactivates the lighting, thereby leaving maintenance personnel with no lighting. Remove motion type switch to a conventional on/off switch.	7/10/2020
MO Minimum : Elevators	(G) - Maintenance, Repair and Replacements	(G)1 - 8.6.4.13.1(l) Means to restrict hoistway/car door opening (Door Restrictors) (Re-Inspection)		The car door restrictor device shall be adjusted so that it will properly catch and restrict opening of the car doors to a maximum of 4 inches when the car is away from the landing zone. Reinspection is required.	10/31/2019
MO Minimum : Elevators	(G) - Maintenance, Repair and Replacements	(G)1 Maintenance, Repair and Replacements		A grease seal on the drive machine is leaking excessively and shall be replaced.	7/10/2020
A17.1-1996 : Elevators	2.19 - Gears, bearings, and flexible couplings	1001.2(b)(17) - no reinspect		A grease seal on the drive machine is leaking excessively and shall be replaced.	7/10/2020
A17.1-1996 : Elevators	2.11 - Disconnecting Means and Control	210.4		Sprinkler heads have been added to the elevator machine room without the required heat detectors to activate the shunt trip disconnect before the application of water. Heat detectors shall be installed within 2’ of each sprinkler head to activate the shunt trip disconnect.	7/10/2020
A17.1-2016 : Elevators	1.17 - Standby power operation	8.6.4.19.7 (Re-Inspection)	x	Standby power needs to be tested. Re-inspection required	11/15/2023

Back