Inspection

Inspection Details

Equipment ID
18399

Inspection Date
8/21/2023

Inspection Type
Reinspection

Inspector Name
Michial Linenfelser

Mechanic Name
Thomas Jimas

Relief Valve Pressure
Na

Slide
13.5”

Governor Rope Pull
30/250

Door Closing Force
29/25

External ID
05fa267b-fd9e-420f-933f-04159a9bdeaa

Location

Ely Walker Lofts
1520 Washington Ave, St. Louis, MO
Phone: (314) 591-9715

Owner

Attn: Ely Walker Condo Assoc.
Ely Walker Condo Assoc.
1520 Washington Ave, St. Louis, MO 63103
Phone: (000) 000-0000
Email: bobbie@cpmgateway.com

Billing

Attn: Ely Walker Condo
Ely Walker Condo c/o Sentry Management
9666 Olive Blvd, Ste 116, St. Louis, MO 63132
Phone: (314) 994-7440 Ext: 57500
Email: AJohnson@smithmgmt.com

Violations

Code	Item	Section	Reinspection	Red Tag	Reason For Violation	Fixed Date
A17.1-1996 : Elevators	1.6 - Car emergency signal	1001.2(a)(6) (Phone or alarm not functioning (Mandatory Re-Inspection due in 14 days)	x		Phone inoperative. Repair	8/28/2019
A17.1-1996 : Elevators	6.4 - Firefighters' service (A17.1b-1989 and later editions)	211.2-211.8	x	x	Door open button inoperative on Phase 11 recall. Phase II hold inoperative. Repair. 211.3 Elevator NOT red-tagged. Reinspect.	8/28/2019
A17.1-1996 : Elevators	1.6 - Car emergency signal	1001.2(a)(6) (Phone or alarm not functioning (Mandatory Re-Inspection due in 14 days)	x		Phone inoperative. Technician measured full voltage signal on incoming line.	7/28/2020
A17.1-1996 : Elevators	2.13 - Governor,overspeed switch and seal	205.15	x		Governor measured a "type C" sheave condition. Repair governor within a 6-mth time period from test date.	7/28/2020
A17.1-1996 : Elevators	5.1 - Pit access, lighting, stop switch, and condition	106.1e Illumination of Pits			Clean pit.	5/1/2020
ASME A17.1 2004 with 2005 Addendum and 2005 : Elevators	1.6 - Car emergency signal	8.11.2.1.1(f) (Insp code) Phone or alarm not functioning (Mandatory Re-Inspection due in 14 days)	x		Repair emergency cab phone.	7/16/2021
ASME A17.1 2004 with 2005 Addendum and 2005 : Elevators	2.13 - Governor,overspeed switch and seal	2.18	x	x	The governor pull-through force is excessive. The pull-through force was over 700 lbs. repair or replacement of governor is required. If the governor is replaced, an alteration permit is required along with a reinspection. The governor rope may need to be replaced as well.	8/21/2023
MO Minimum : Elevators	11 CSR 40-5.090 Inspection and Testing	(3) Testing Procedures (Re-Inspect)	x		The testing has not been completed on the elevator at this time. The weight test shall be performed, safeties set, fireman’s service, emergency systems,and buffers compressed before the inspection is completed.	8/21/2023
MO Minimum : Elevators	(G) - Maintenance, Repair and Replacements	8.6.1.6.7 Signs and Data Plates			The signage for “In Case of Fire Use Stairs” is not located on all landings.. Install signage that conforms to the building code this elevator was installed to meet.	8/1/2023
ASME A17.1 2004 with 2005 Addendum and 2005 : Elevators	2.12 - Controller Wiring, Fuses, Grounding, Etc.	8.6.1.6.1			The emergency rescue battery in the controller shall be changed. The Manufacture’s written procedure is for replacement every 3 years. If the battery becomes depleted the elevator will automatically stop operating. Replace the battery of this elevator before it shuts down due to battery being depleted.	8/1/2023
ASME A17.1 2004 with 2005 Addendum and 2005 : Elevators	2.6 - Ventilation	2.7.5.2			The HVAC unit in the machine room shall be repaired to provide proper operation temperature for the elevator controller.	8/1/2023
MO Minimum : Elevators	(G) - Maintenance, Repair and Replacements	8.6.1.6.7 Signs and Data Plates			The fireman’s emergency service phase II instruction signage adjacent to the keyed switch in the car is unreadable and shall be replaced..	8/1/2023
MO Minimum : Elevators	(G) - Maintenance, Repair and Replacements	8.6.1.6.7 Signs and Data Plates			The signage for “In Case of Fire Use Stairs” is not located on all landings.. Install signage that conforms to the building code this elevator was installed to meet.	8/1/2023
ASME A17.1 2004 with 2005 Addendum and 2005 : Elevators	2.12 - Controller Wiring, Fuses, Grounding, Etc.	8.6.1.6.1			The emergency rescue battery in the controller shall be changed. The Manufacture’s written procedure is for replacement every 3 years. If the battery becomes depleted the elevator will automatically stop operating. Replace the battery of this elevator before it shuts down due to battery being depleted.	8/1/2023
ASME A17.1 2004 with 2005 Addendum and 2005 : Elevators	2.6 - Ventilation	2.7.5.2			The HVAC unit in the machine room shall be repaired to provide proper operation temperature for the elevator controller.	8/1/2023
MO Minimum : Elevators	(G) - Maintenance, Repair and Replacements	8.6.1.6.7 Signs and Data Plates			The fireman’s emergency service phase II instruction signage adjacent to the keyed switch in the car is unreadable and shall be replaced..	8/1/2023
MO Minimum : Elevators	CSR 40-5.100 State Operating Certificate	5.100(2) Display of Operating Certificate			A copy of the current state operating certificate shall be displayed in the machine room
MO Minimum : Elevators	(I) - Pits	(I)1			Pit needs to be cleaned
MO Minimum : Elevators	(G) - Maintenance, Repair and Replacements	8.6.3.1 Replacement Parts			Need to replace missing direction arrows in car door jamb
MO Minimum : Elevators	(G) - Maintenance, Repair and Replacements	8.6.1.6.5 Fire Extinguishers			Fire extinguisher in machine room needs to be hung on wall to meet fire code
MO Minimum : Elevators	(G) - Maintenance, Repair and Replacements	8.6.3.1 Replacement Parts			Need to replace illegible bezels for car operating panel buttons: Car cancel and phone
ASME A17.1 2004 with 2005 Addendum and 2005 : Elevators	2.6 - Ventilation	2.7.5.2			The HVAC unit in the machine room shall be repaired to provide proper operation temperature for elevator controller

Back