Inspection

Inspection Details

Equipment ID
25795

Inspection Date
12/23/2025

Inspection Type
Annual Inspection

Inspector Name
Chad Hackstadt

Mechanic Name
Brant Willtrout

Relief Valve Pressure
NA

Slide
Soft set

Governor Rope Pull
NA

Door Closing Force
26

External ID
4c148177-b36a-4352-92dd-272f32da3aa7

Location

3681 Lindell
3681 Lindell Blvd, St. Louis, MO
Phone: (314) 540-5988
Email: bhayden@stlluxury.com

Owner

Attn: Bryan Hayden
St. Louis Luxury
3681 Lindell Blvd, St. Louis, MO 63108
Phone: (314) 540-5988
Email: bhayden@stlluxury.com

Billing

Same as Owner

Violations

Code	Item	Section	Reinspection	Red Tag	Reason For Violation	Fixed Date
A17.1-2016 : Elevators	3.12 - Pipes, wiring, and ducts	2.8	Yes	No	Secure metallic wiring properly in top of hoistway.	1/30/2025
A17.1-2016 : Elevators	3.12 - Pipes, wiring, and ducts	2.8	Yes	No	Top of hoistway lighting switch must be accessible & visible from both landings.	1/30/2025
A17.1-2016 : Elevators	3.12 - Pipes, wiring, and ducts	2.8	Yes	No	GFI located in top of hoistway shall work.	1/30/2025
A17.1-2016 : Elevators	2.3 - Lighting and receptacles	2.7.9.1	Yes	No	Machine space lighting shall be not less than 19fc with cartop level on top floor, as measured from the cartop.	1/30/2025
A17.1-2016 : Elevators	3.10 - Hoistway construction	2.1	Yes	No	Orange spray foam "Fire Block" not allowed. Product is not compliant with IBC or NFPA 72 as 1.5hr fire rated fire penetration sealant for commercial applications. Hoistway penetration sealant must be a compliant fire resistive sealant product. Replace/recover with compliant product. Non-compliance statement can be found on the back of the cans of the existing orange sealant.	1/30/2025
A17.1-2016 : Elevators	3.10 - Hoistway construction	2.1	Yes	No	Yellow spray foam insulation not allowed. Product is not compliant with IBC or NFPA 72 as a 1.5hr fire rated fire penetration sealant for commercial applications. Hoistway wall covering must be a compliant fire restrictive product. Replace/recover with compliant product or provide compliance rating documentation for current sealant. Contractor indicated they may apply DC315 Coating at a minimum wet film thickness of 24mil wet (based on ICC ESR-3500 for Proseal LE) will create the thermal barrier needed and maintain the integrity of the insulation in the event of a hoistway fire.	1/30/2025
A17.1-2016 : Elevators	3.10 - Hoistway construction	2.1	Yes	No	There is exposed wood, without fire-rated coating, throughout the hoistway, under sill, etc.	1/30/2025
A17.1-2016 : Elevators	5.1 - Pit access, lighting, stop switch, and condition	2.2.2.5 Sump Pump Required/Capacity (Re-Inspect)	Yes	No	Provided pit sump pump documentation to ensure proper capacity (3000 GPH per elevator at 14' of head) and the presence of automatic float operation (no float switch seen at this time).	1/30/2025
A17.1-2016 : Elevators	2.3 - Lighting and receptacles	2.7.9.1	Yes	No	Lighting at controller access floor (10th floor) shall not be less than 19fc, measured at the floor level.	1/30/2025
MO Minimum : Elevators	(G) - Maintenance, Repair and Replacements	8.6.1.6.7 Signs and Data Plates	Yes	No	Mainline and lighting disconnects need feeder location labeling.	1/30/2025
A17.1-2016 : Elevators	2.7 - Fire Extinguisher	8.6.1.6.5	Yes	No	10th floor fire extinguisher shall be ABC rated, not just BC rated.	1/30/2025
A17.1-2016 : Elevators	6.4 - Firefighters' service (A17.1b-1989 and later editions)	2.27.3.2 Phase I Operation Recall by Initiating Device	Yes	Yes	FAID failed to initiate elevator recall. Test all devices.	1/30/2025
A17.1-2016 : Elevators	6.4 - Firefighters' service (A17.1b-1989 and later editions)	2.27.3.1.1 Phase I Emergency Recall Operation	Yes	Yes	Lobby fire status panel display damaged. Repair and fully test.	1/30/2025
A17.1-2016 : Elevators	2.8 - Pipes, wiring, and ducts	2.8	Yes	No	Fire suppression/sprinkler systems in elevator lobbies not fully installed at this time. Verification of completed installation required.	1/30/2025

Back