Inspection

Inspection Details

Equipment ID
25606

Inspection Date
7/15/2021

Inspection Type
Alteration

Inspector Name
Michial Linenfelser

Mechanic Name
Marcus Geno

Relief Valve Pressure
420

Slide

Governor Rope Pull

Door Closing Force
Na

External ID
b53b8a65-0c77-460a-bd83-5ad6719cbd82

Location

314 Building
314 N Jefferson Ave, St. Louis, MO
Phone: (314) 621-3440

Owner

Attn: Hudson Company
Hudson Company
PO Box 220425, St. Louis, MO 63122
Phone: (000) 000-0000

Billing

Same as Owner

Violations

Code	Item	Section	Reinspection	Reason For Violation	Fixed Date
MO Minimum : Elevators	(A) - Hoistways	(A)12		Hoistways containing freight elevators shall be fully enclosed. There were two access doors noted on the rear wall of the hoistway (Top of floor 2 and top of floor 3), along with an access door in the ceiling of the hoistway that accesses the roof. All access doors shall be permanently closed (mechanically fastened or welded shut) to eliminate access to the hoistway.	1/25/2022
MO Minimum : Elevators	(C) - Car Enclosure: Freight	(C)5		The light bulb inside the freight enclosure shall be guarded to prevent breakage.	1/25/2022
MO Minimum : Elevators	(F) - Electrical Switches	(F)9		The existing shorting bars in the mainline elevator disconnect shall be replaced with fuses properly sized for the application.	1/25/2022
MO Minimum : Elevators	(G) - Maintenance, Repair and Replacements	8.6.1.4.1(a) On-Site Maintenance Records (MCP Records)		A written Maintenance Control Program shall be in place to maintain the equipment in compliance with the requirements of Section 8.6, along with the required on-site documentation and maintenance records provided.	1/25/2022
MO Minimum : Elevators	(G) - Maintenance, Repair and Replacements	8.6.1.5 Code Data Plate		A code data plate shall be provided and securely attached to the main line disconnect or controller stipulating this elevator to be inspected to Missouri Minimums.	1/25/2022
MO Minimum : Elevators	(G) - Maintenance, Repair and Replacements	8.6.2.1 Repair Parts		The elevator did have a run/stop switch located on the top of the car. However, it had been broken off. A new run/stop switch shall be provided.	1/25/2022
MO Minimum : Elevators	(G) - Maintenance, Repair and Replacements	8.6.1.6.5 Fire Extinguishers		A Class “ABC” fire extinguisher shall be provided in the elevator machine room, convenient to the access door.	1/25/2022
MO Minimum : Elevators	(G) - Maintenance, Repair and Replacements	(G)1 - Door Systems 8.6.4.13 (Re-Inspection)	x	The front car gate was too loose between the guides and running uneven. This gate shall have the door guides and relating cables adjusted for smooth and secure door operation.	1/25/2022
MO Minimum : Elevators	(G) - Maintenance, Repair and Replacements	8.6.2.1 Repair Parts		There was a junction box above the traveling cable that was not completely secured to the wall. This box shall be secured to prevent future damage to the elevator electrical components.	1/25/2022
MO Minimum : Elevators	(H) - Machine Rooms	(H)2		The elevator machine and control equipment shall be located in a separate room or separated space. Other mechanical equipment can be located in the room but must be separated by a 6-foot fence with a self-closing and self-locking gate, operable from the interior space without use of a key. Pipes conveying liquid, gas, or vapor that cross overhead of elevator equipment shall be guarded or guttered.	1/25/2022
MO Minimum : Elevators	(O) - Existing Hydraulic Elevators	(O)2		The pressure relief valve on the hydraulic power unit was set too high. The unit is slated for immediate replacement and the new hydraulic pump shall conform to this section. The new relief valve shall be preset to open at a pressure not greater than that necessary to maintain one hundred twenty-five percent (125%) of working pressure.	1/25/2022

Back